The TPMC861 is a standard single-width 32 bit PMC module with four channels of high performance RS422/485-HD/FD serial interface. Each of the four channels is isolated from the system and against each other by optocoupler and on board DC/DC converter per channel.

The serial channels are accessible through a DB25 connector mounted in the front panel and via P14 I/O. Each channel has a 128byte transmit FIFO and a 128byte receive FIFO to significantly reduce the overhead required to provide data to and get data from the transmitter and receivers. The FIFO trigger levels are programmable. For RS422 and RS485-FD a four wire interface (RX+, RX-, TX+, TX-) plus isolated ground (GND) per channel is supported. For RS485-HD a two wire interface (DX+, DX-) plus isolated ground (GND) per channel is supported. The baud rate is individually programmable up to 460.8Kbaud for each channel. The interrupts are supported.

All channels generate interrupts on PCI interrupt INTA. For fast interrupt source detection the TPMC861 provides a special interrupt status register. Each receiver input and transmitter output of all channels is protected against electrostatic discharge (ESD) up to +/- 15kV according to IEC 1000-4-2.

Technical Specifications

Manuals

TPMC861	Data Sheet
TPMC861-DOC	User Documentation for TPMC861
TPMC861-SW-42	VxWorks Software Support for TPMC861
TPMC861-SW-72	LynxOS Software Support for TPMC861
TPMC861-SW-82	LiNUX Software Support for TPMC861